Chisel bits
　　Cross bits
　　X Type bits
　　Full Steel Bits
　　Button Bits
　　Blasting furnace Taping hole bits
　　Drilling Rod
　　Intergral Drill Rods
　　Shank Adapter
　　Coupling
　　DTH Hammer Bits
　　DTH Hammers
　　Overburden Drilling
　　Tricone bits
　　Drag Bits
　　PDC Drill bits
　　Rock drill
　　Breaker Rods
　　Diamond Wire Saw
　　Hydraulic splitters
　　Bucket Teeth and Holder
　Your position>>> DTH Hammer Bits>>>Brief Introduction
   

Bit face shape selection

DropCenter Bit
For high penetration rates in soft to medium-hard and fissured rock formations. Low to medium air pressures. Maximum hole deviation control.

Concave face
The all-round application bit face specifically for medium hard and homogenerous rock formations. Good hole deviation control and good flushing capacity.

Convex face
For high penetration rates in soft to medium-hard with low to medium air pressures. It is the most resistance to steel wash, and may reduce the load and wear on the gauge buttons, but poor hole deviation control.

Double Gauge face
This kind of face shape is suitable for fast penetration rates in medium to hard rock formations. Designed for high air pressures and good resistance to steel wash step gauge bit.

Flat Face Bit
This kind of face shape is suitable for hard to very hard and abrasive rock formations in applications with high air pressures. Good penetration rates an resistance to steel wash.